Super-Freq Vintage Silver

$479.00

The Mu-Tron SUPER-FREQ is a dual state variable filter with multiple routing and actuating options. Either filter can be run as an ENVELOPE FILTER, WAH-WAH pedal, or a PARAMETRIC EQ with resonance control. It can be used in STEREO, MONO IN -DUAL OUT , or MONO-SERIES to allow for limitless applications.

Out of stock

Description

Stereo Envelope Filter, Wah-Wah, and Parametric

The Mu-Tron SUPER-FREQ is a dual state variable filter with multiple routing and actuating options. Either filter can be run as an ENVELOPE FILTER, WAH-WAH pedal, or a PARAMETRIC EQ with resonance control. It can be used in STEREO, MONO IN -DUAL OUT , or MONO-SERIES to allow for limitless applications.

A state variable filter is a type of active filter in electronic circuits which can produce simultaneous lowpass, highpass, and bandpass outputs from a single input. State variable filters are frequently used for modifying frequency response in audio signal processing. At low Q settings they are often used in parametric equalizer circuits, and at high or variable Q settings to create resonant filter modules in analog synthesizers. For manual control of frequency, dual potentiometers are usually employed as in the Tychobrahe Parapedal, Alembic SF-2, and Anderton Super Tone Control. The SUPER-FREQ utilizes optical circuits to servo both filters simultaneously. Both the Mu-Tron III and the Mu-Tron Vol-Wah are examples of optically controlled state variable filters. The Mu-Tron III translates the musician’s playing dynamics into current which then drives an LED. The Mu-Tron Vol-Wah uses a potentiometer in the foot pedal to sweep current to the LED. The LED in either design then servos multiple photo-resistors to vary the resistance of the state variable filter.

State Variable Filter
State Variable Filter

Features and Improvements:

  • Modular optical design which allows for consistency across units.
  • Optical servo of both filters simultaneously is built into the pedal.
  • Original bi-polar internal voltage insures high headroom and low noise
  • Independent effect block can be combined in series or parallel operation
  • Pedal control assignable to rate to achieve “Wah-Wah” sweep with foot
  • Envelope control of either filter
  • LED (light emitting diode) indicators to show operating status of effects.
  • Routes signal from right to left to be more pedal board friendly.
  • Operates on standard  9v  (negative center tip, 100mA power port)
  • Multiple routing capabilities

Controls:

  • Frequency controls the range of frequency manipulation.
  • Peak controls can be used as resonance or damper control.
  • Low pass, Band pass, and High pass modes.
  • Up and Down drive for either Envelope can be fined tuned internally.
  • Direct gain to allow for dry signal to be blended with filtered signal.

Specifications:

  • 2 1/4″ Input Jacks
  • 2 1/4″ Output Jacks
  • 9V-12V DC
  • Draws 110 mA
  • Weight: 1 lbs
  • Dimensions: 4.75″ x 2.5″ x 7.25″
  • 1 Year Limited Warranty
  • Made in the US

Super-Freq Quickstart Guide

⚠ WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Additional information

Weight 24 oz
Dimensions 8 × 6 × 3 in

Reviews

There are no reviews yet.

Be the first to review “Super-Freq Vintage Silver”